Helmet Jet VESPA Heritage Biancospino
Article information
Jet helmet with 5 snaps. Thermoplastic shell. Chromed edge finishing. Micrometric retention system. High resistant suede lining. Removable and washable cheek pads. UV proof painting. Sizes from XS to XL. ECE 22.05 homologated.
Polycarbonate shell
A polycarbonate outer shell is relatively cheap to produce, which makes the helmets affordable. The helmet is produced by using a mould where the material is poured and compressed. By using plasticizers, the plastic becomes elastic. Through exposure to UV-light and various weather conditions, these plasticisers deteriorate. This means that a polycarbonate helmet should be replaced after approximately 5 years.
Perimetrical rim
The outer shell is finished with a plastic rim. This not only provides a neat finish but also offers protection to the outer shell. If the helmet is dropped on the ground, it is not immediately damaged.
Luxury inner lining
The inner lining is more luxurious compared to the standard lining. The lining is made of refined materials and has a luxurious look. The colours of the lining match the exterior of the helmet. The luxury lining can often be found on the more expensive helmets.
Micrometric buckle
The micrometric buckle is the most frequently used buckle on helmets and easy to use. The rattle buckle ensures that it can be adjusted to the correct position. The buckle is easily opened by pulling the red loop.
Helmet graphics with scratch resistant varnish
Each helmet is carefully treated to achieve the right finish. After the helmet has been smoothed, it is sprayed in several layers of colour. Then the helmet is covered with water-based graphics. Finally, the helmet is covered with a transparent scratch-resistant lacquer.
Removable cheek pads
In addition to the inner lining, the cheek pads can also be removed. These are attached with velcro or several press-studs. Washing the cheek pads with neutral soap will keep them fresh. Make sure that the cheek pads are dry when they are put back into the helmet.
Goggles fixation
On the back of the helmet, there is a leather strap with a press stud. The elastic of the helmet goggles can be threaded through here. In this way, the elastic strap stays on the helmet while riding.
Sun peak with snap buttons
The sun peak is simply attached to the snaps of the helmet. If the visor is not used, it can easily be removed. The snaps are visible on the helmet. The sun peak blocks most of the sun rays and gives the helmet a special look.
Sizes XS-S-M-L-XL
The size of the helmet is determined by the number of centimeters of head circumference. The size is measured with a measuring tape above the ears along the widest part of the head. The number of centimeters determines the size. The sizes are however an indication. This is no guarantee that the helmet will fit. Check per brand how the size is calculated.Click here to determine your helmet size.
ECE 22-05 certification
If you want to participate in traffic on a moped, scooter or motorbike in Europe you are obliged to wear a helmet with the ECE certification. This certification meet of a number of minimum requirements that a helmet must pass. The ECE certification can be found on the label attached to the chinstrap.Specifications
| Size | : | XS / 53-54cm |
| Type | : | Jet |
| Color | : | White |
| Collection | : | Heritage |
Fits
Helmet Jet VESPA Heritage Biancospino fits the following vehicles:Documentation
Other (Italian):
certificati_casco_vintage...
certificati_casco_vintage...
Specifications (Multiple languages):
VESPA_Inspiration.pdf
VESPA_Inspiration.pdf
Additional products
|
No additional products were found. |
Recommended products
Spare parts
