Helmet Jet VESPA Nation 2.0 UK
Article information
Jet helmet with 5 snaps. Thermoplastic shell. Micrometric retention system. High resistant lining. Vespa unique chromed finishing on the edge of the shell. Removable washable cheek pads. UV proof painting. ECE 22.05 homologated.
Polycarbonate shell
A polycarbonate outer shell is relatively cheap to produce, which makes the helmets affordable. The helmet is produced by using a mould where the material is poured and compressed. By using plasticizers, the plastic becomes elastic. Through exposure to UV-light and various weather conditions, these plasticisers deteriorate. This means that a polycarbonate helmet should be replaced after approximately 5 years.
Perimetrical rim
The outer shell is finished with a plastic rim. This not only provides a neat finish but also offers protection to the outer shell. If the helmet is dropped on the ground, it is not immediately damaged.
Perforated inner lining
The ventilation system in the helmet ensures a constant air flow. Through the perforated inner lining, this air, which enters through the air channels, can also reach the skin. This way it always stays cool inside the helmet. In winter, the ventilation system can be closed so no air enters the helmet.
Extra soft inner lining
By using softer materials compared to the standard lining, the helmet provides even more comfort. During a long ride, the soft lining is absolutely noticeable.
Micrometric buckle
The micrometric buckle is the most frequently used buckle on helmets and easy to use. The rattle buckle ensures that it can be adjusted to the correct position. The buckle is easily opened by pulling the red loop.
Helmet graphics with scratch resistant varnish
Each helmet is carefully treated to achieve the right finish. After the helmet has been smoothed, it is sprayed in several layers of colour. Then the helmet is covered with water-based graphics. Finally, the helmet is covered with a transparent scratch-resistant lacquer.
Anti-theft ring
The chin strap of the helmet is equipped with a metal ring. By using this ring, the helmet can be attached to the hook under the saddle. In this way, theft is prevented.
Goggles fixation
On the back of the helmet, there is a leather strap with a press stud. The elastic of the helmet goggles can be threaded through here. In this way, the elastic strap stays on the helmet while riding.
Sun peak with snap buttons
The sun peak is simply attached to the snaps of the helmet. If the visor is not used, it can easily be removed. The snaps are visible on the helmet. The sun peak blocks most of the sun rays and gives the helmet a special look.
Sizes XS-S-M-L-XL
The size of the helmet is determined by the number of centimeters of head circumference. The size is measured with a measuring tape above the ears along the widest part of the head. The number of centimeters determines the size. The sizes are however an indication. This is no guarantee that the helmet will fit. Check per brand how the size is calculated.Click here to determine your helmet size.
ECE 22-05 certification
If you want to participate in traffic on a moped, scooter or motorbike in Europe you are obliged to wear a helmet with the ECE certification. This certification meet of a number of minimum requirements that a helmet must pass. The ECE certification can be found on the label attached to the chinstrap.Specifications
| Size | : | XS / 53-54cm |
| Type | : | Jet |
| Color | : | Multi color |
Fits
Helmet Jet VESPA Nation 2.0 UK fits the following vehicles:Additional products
|
No additional products were found. |
Recommended products
Spare parts
