Helmet full face CGM 310P Moonlight Carbon/ Kevlar pearl white
Article information
CLEARANCE!
SALE!
Polycarbonate shell
A polycarbonate outer shell is relatively cheap to produce, which makes the helmets affordable. The helmet is produced by using a mould where the material is poured and compressed. By using plasticizers, the plastic becomes elastic. Through exposure to UV-light and various weather conditions, these plasticisers deteriorate. This means that a polycarbonate helmet should be replaced after approximately 5 years.Front and/or rear ventilation system
The ventilation system consists of air inlets at the front and/or rear. Through air channels in the inner shell, the incoming air is guided through the helmet. In this way, the rider experiences a constant air flow which also guarantees a pleasant temperature inside the helmet.Perimetrical rim
The outer shell is finished with a plastic rim. This not only provides a neat finish but also offers protection to the outer shell. If the helmet is dropped on the ground, it is not immediately damaged.Long Visor with anti-scratch treatment
The visor can be damaged during use. The small scratches can reduce visibility on sunny days. The anti-scratch coating makes the visor less prone to damage. However, do not let sharp objects such as jewellery or keys come into contact with the visor. Because of the coating, the visor should only be cleaned with water and dish soap. Use of strong detergents can damage the coating.Removable inner lining
The inner lining is attached to the inner shell by snaps or velcro. The removable inner lining can be washed with neutral soap. In this way, the lining remains in good quality and the helmet fresh. In addition to the inner lining, the cheek pads are also removable.Perforated inner lining
The ventilation system in the helmet ensures a constant air flow. Through the perforated inner lining, this air, which enters through the air channels, can also reach the skin. This way it always stays cool inside the helmet. In winter, the ventilation system can be closed so no air enters the helmet.Extra soft inner lining
By using softer materials compared to the standard lining, the helmet provides even more comfort. During a long ride, the soft lining is absolutely noticeable.Micrometric buckle
The micrometric buckle is the most frequently used buckle on helmets and easy to use. The rattle buckle ensures that it can be adjusted to the correct position. The buckle is easily opened by pulling the red loop.Helmet graphics with scratch resistant varnish
Each helmet is carefully treated to achieve the right finish. After the helmet has been smoothed, it is sprayed in several layers of colour. Then the helmet is covered with water-based graphics. Finally, the helmet is covered with a transparent scratch-resistant lacquer.Sizes XS-S-M-L-XL
The size of the helmet is determined by the number of centimeters of head circumference. The size is measured with a measuring tape above the ears along the widest part of the head. The number of centimeters determines the size. The sizes are however an indication. This is no guarantee that the helmet will fit. Check per brand how the size is calculated.Click here to determine your helmet size.
ECE 22-05 certification
If you want to participate in traffic on a moped, scooter or motorbike in Europe you are obliged to wear a helmet with the ECE certification. This certification meet of a number of minimum requirements that a helmet must pass. The ECE certification can be found on the label attached to the chinstrap.Specifications
Size | : | L / 59-60cm |
Type | : | Full face |
Color | : | White |
Fits
Helmet full face CGM 310P Moonlight Carbon/ Kevlar pearl white fits the following vehicles:Additional products
No additional products were found. |
Recommended products