Helmet Cross CGM 610P Moonshine Carbon/ Kevlar Pearl White XXL
Article information
CLEARANCE!
SALE!
Polycarbonate shell
A polycarbonate outer shell is relatively cheap to produce, which makes the helmets affordable. The helmet is produced by using a mould where the material is poured and compressed. By using plasticizers, the plastic becomes elastic. Through exposure to UV-light and various weather conditions, these plasticisers deteriorate. This means that a polycarbonate helmet should be replaced after approximately 5 years.Front and/or rear ventilation system
The ventilation system consists of air inlets at the front and/or rear. Through air channels in the inner shell, the incoming air is guided through the helmet. In this way, the rider experiences a constant air flow which also guarantees a pleasant temperature inside the helmet.Perimetrical rim
The outer shell is finished with a plastic rim. This not only provides a neat finish but also offers protection to the outer shell. If the helmet is dropped on the ground, it is not immediately damaged.Perforated inner lining
The ventilation system in the helmet ensures a constant air flow. Through the perforated inner lining, this air, which enters through the air channels, can also reach the skin. This way it always stays cool inside the helmet. In winter, the ventilation system can be closed so no air enters the helmet.Micrometric buckle
The micrometric buckle is the most frequently used buckle on helmets and easy to use. The rattle buckle ensures that it can be adjusted to the correct position. The buckle is easily opened by pulling the red loop.Helmet graphics with scratch resistant varnish
Each helmet is carefully treated to achieve the right finish. After the helmet has been smoothed, it is sprayed in several layers of colour. Then the helmet is covered with water-based graphics. Finally, the helmet is covered with a transparent scratch-resistant lacquer.Sun visor (attached)
This sun visor is attached to the helmet by bolts. If required, the visor can be removed with tools. The main function of the sun visor is to protect the driver from sunlight. This sun visor is often found on cross helmets. The visor also protects the driver from splashing mud.Sizes XS-S-M-L-XL-XXL
The size of the helmet is determined by the number of centimeters of head circumference. The size is measured with a measuring tape above the ears along the widest part of the head. The number of centimeters determines the size. The sizes are however an indication. This is no guarantee that the helmet will fit. Check per brand how the size is calculated.Click here to determine your helmet size.
Rear air system
This helmet is equipped with rear air extractors. The air circle is generated by exploiting the movement, which creates a negative pressure and pushes the hot air inside towards the back of the helmet from where it comes out through the rear air extractors. In this way, the pilot benefits from a constant recycling of air inside the helmet, which always guarantees a temperature.ECE 22-05 certification
If you want to participate in traffic on a moped, scooter or motorbike in Europe you are obliged to wear a helmet with the ECE certification. This certification meet of a number of minimum requirements that a helmet must pass. The ECE certification can be found on the label attached to the chinstrap.Specifications
Size | : | XXL / 63-64cm |
Type | : | Cross |
Color | : | White |
Fits
Helmet Cross CGM 610P Moonshine Carbon/ Kevlar Pearl White XXL fits the following vehicles:Recommended products