Shock absorber MALOSSI RS24/10-R L.330mm Yamaha T-Max 530i E4 2017->

Article information

- Type: oleopneumatic shock absorber with separate compensation tank
- Use: competition scooter
- Damper rod Ø 14 mm steel 38NCD4 - tempered and tempered with a 25/30 micron hard chrome deposit (hardness of the untreated ash surface HRC 55/60)
- Ø 36 mm piston with two independent slat blocks: one in compression and the other in extension
- New harmonic steel lamellar system that enables highly accurate calibration
- LUBRIFLON-PTFE B70 piston sliding shoe (modified composite loaded bronze)
- Sliding on the sleeve-GUIDED OF (connection obtained by sintering a layer of spherical bronze on a strip of mild steel, correctly pressed with successive impregnation and postponement of a mixture of PTFE PB)
- SEALTHANE polyester resin scraper ring grade 9345
- Micrometric control of the spring preload by means of nuts
- Control of hydraulic brakes in extension, pre-adjustable in 24 positions
- Double control of the hydraulic compression braking, each pre-adjustable at approximately 10 positions, separated on the basis of low and high speed
- Special oil with low viscosity and almost insensitive to temperature fluctuations
- External compensation tank that allows an increase in the quantities of internal liquids
- 25 mm adjustment between the axles (only for rear shock absorber)
- Intermediate shaft: rear 321 25 mm - front 181 mm
- Race: rear 62 mm - front 45 mm